👍 What we like
- All three are M.2 2280 PCIe 4.0 drives, the standard for most mini-PCs
- TLC NAND on both Samsung drives, with published manufacturer data
- Choice between a DRAM model and a more frugal DRAM-less model
- Work in PCIe 3.0 slots (at reduced throughput)
👎 What to watch
- No hardware power-loss protection (PLP) on these consumer SSDs
- Heatsink versions are often too thick for a mini-PC
- Can run hot under sustained writes in a closed case
- Won't work in a SATA-only M.2 slot
📑 Contents ▾
Storage in a mini-PC almost always comes down to one or two M.2 slots. On a recent mini-PC running Proxmox, Home Assistant, Docker containers or a small file server, the NVMe SSD holds the operating system, the virtual machines and often the data as well. The small form factor adds its own constraints: you have to respect the module length and the slot interface (PCIe or SATA), and deal with heat in a poorly ventilated case and with idle power on a machine that never switches off.
This guide compares three PCIe 4.0 M.2 2280 NVMe SSDs with different profiles: the Samsung 990 PRO 4TB (high-end, with DRAM), the Samsung 990 EVO Plus 2TB (DRAM-less, frugal, built for efficiency) and the Crucial T500 2TB (PCIe 4.0 with a DRAM cache). The specifications quoted come from the manufacturers’ official spec sheets. Where a figure could not be confirmed at the source, we say so.
Note: the previous version of this page included a 2.5-inch enterprise SATA SSD. That is not an NVMe SSD, and many mini-PCs have no 2.5-inch bay, so it has been removed from the comparison. SATA is still covered further down.
Selection criteria
1. Physical format: M.2 2280, 2242 or 2230
The number after “M.2” gives the module’s width and length in millimetres: a 2280 measures 22 × 80 mm. Most desktop mini-PCs take 2280 drives. Some very compact models, handheld consoles and add-on boards only take 2242 or 2230. Check the maximum length in your machine’s manual. All three SSDs in this guide are M.2 2280.
Thickness matters too. A heatsink version usually won’t fit in a mini-PC: pick the bare version with a plain label.
2. Slot interface: PCIe/NVMe or SATA
An M.2 slot can be wired for PCIe (NVMe), for SATA, or for both. An NVMe SSD in a SATA-only M.2 slot will not be detected. Also check the slot’s generation and lane count (PCIe 3.0 x4, 4.0 x4, sometimes x2 or x1 on entry-level machines). A PCIe 4.0 SSD works in a PCIe 3.0 slot, but the slot then caps its speed. In a homelab mini-PC you will rarely notice: virtual machines and containers depend mostly on random access and latency, not on peak sequential throughput.
3. Cache: DRAM or HMB
An SSD with DRAM carries a small dedicated memory that holds, among other things, the address mapping table. A DRAM-less SSD uses HMB (Host Memory Buffer): it borrows a small part of the system RAM over the PCIe bus. Recent DRAM-less SSDs have become very fast for everyday use, and they often draw less power, which suits a mini-PC well. Models with DRAM keep the edge under heavy, sustained writes. HMB has one requirement: the operating system must support it. Recent Linux kernels and Windows versions do.
4. Endurance (TBW) and warranty
TBW (terabytes written) is the volume of writes the warranty covers. In a homelab, writes come mostly from logs, databases, virtual machines and ZFS. For example, Samsung gives the 990 PRO 4TB a limited warranty of 5 years or 2,400 TBW, whichever is reached first (Samsung Canada spec page). Terms can vary by country: check the spec page for your region.
5. Heat and power
In a mini-PC the SSD often sits under the motherboard or against the lid, with little airflow. A heavily loaded PCIe 4.0 SSD can heat up and slow itself down (throttling). For a machine that runs 24/7, idle power and power management (ASPM, low-power states) matter more than peak draw.
6. Power-loss protection
The consumer SSDs in this guide do not advertise hardware power-loss protection (PLP, capacitors). That feature is mostly found on enterprise SSDs, which are rarely available as consumer M.2 2280 drives. In a mini-PC, protection comes first from a UPS and a clean shutdown triggered by NUT, then from regular backups.
Comparing the options
| Criterion | Samsung 990 PRO 4TB | Samsung 990 EVO Plus 2TB | Crucial T500 2TB |
|---|---|---|---|
| Form factor | M.2 2280 | M.2 2280 | M.2 2280 |
| Interface | PCIe 4.0 x4, NVMe 2.0 | PCIe 4.0 x4 / 5.0 x2, NVMe 2.0 | PCIe 4.0 x4 (see spec sheet for NVMe version) |
| NAND | Samsung V-NAND TLC | Samsung V-NAND TLC | TLC (see spec sheet) |
| Cache | 4 GB LPDDR4 DRAM | DRAM-less (HMB) | DRAM (according to independent reviews) |
| Rated sequential read / write | Up to 7,450 / 6,900 MB/s | Up to 7,250 / 6,300 MB/s | See spec sheet |
| Endurance (TBW) | 2,400 TBW (5-year limited warranty) | See spec sheet | See spec sheet |
Figures taken from Samsung’s official spec pages (France and Canada), read in October 2026. We could not access Crucial’s official spec page, so unconfirmed figures are marked “see spec sheet”.
Samsung 990 PRO 4TB: the high-end pick with DRAM
The 990 PRO 4TB uses PCIe 4.0 x4 and the NVMe 2.0 protocol, with V-NAND TLC and a 4 GB LPDDR4 cache (according to Samsung’s spec page for the 4TB model; the 2TB model has 2 GB). Its 2,400 TBW warranted endurance gives plenty of headroom for a Proxmox host running many virtual machines. It is the best choice if you want one large drive in a mini-PC with a single M.2 slot. It draws more power under load than a DRAM-less model. In a tightly closed case, keep an eye on its temperature during long writes.
Samsung 990 EVO Plus 2TB: the best fit for a mini-PC
The 990 EVO Plus has no DRAM and uses HMB. It supports PCIe 4.0 x4 and PCIe 5.0 x2, with NVMe 2.0 and V-NAND TLC. Samsung highlights its power efficiency and lists a typical idle draw of 60 mW on its spec pages. For an always-on mini-PC (Home Assistant, Docker, small web services), this low-power profile is a good match. For very heavy, continuous writes, a model with DRAM is still the better choice.
Crucial T500 2TB: PCIe 4.0 with a DRAM cache
Despite what some retailer listings suggest, the T500 is not a DRAM-less SSD: independent reviews (TechPowerUp among them) describe a Phison E25 controller paired with an LPDDR4 DRAM cache. It is a PCIe 4.0 x4 M.2 2280 SSD. It also comes in a 4TB capacity and in a heatsink version (which you should avoid in a mini-PC). We could not read Crucial’s official spec page: check the speeds, TBW and NVMe version there before buying.
Recommendations by use case
- Busy Proxmox host (several virtual machines, databases, ZFS): the Samsung 990 PRO 4TB, for its DRAM, large capacity and high warranted endurance.
- Frugal 24/7 mini-PC (Home Assistant, Docker, light services): the Samsung 990 EVO Plus 2TB, for its low idle power and DRAM-less design, which is enough for this kind of load.
- All-rounder with DRAM at 2TB: the Crucial T500 2TB, if you want a model with a DRAM cache without moving up in capacity.
- Mini-PC with two M.2 slots: put the OS and virtual machines on one SSD, and data or local backups on the other. Off-machine backups are still essential.
- You need a 2.5-inch SATA SSD: that is not an NVMe SSD, and it needs a 2.5-inch bay, which many mini-PCs lack. If your machine has one, a SATA SSD can serve as a second drive, but the SATA interface caps its throughput.
Mistakes to avoid
- Confusing interface with memory type. SATA and NVMe are interfaces. TLC and QLC describe the NAND. A SATA SSD can use TLC, just like an NVMe SSD.
- Buying a drive that’s too long. A 2280 won’t fit a slot designed for 2242.
- Putting an NVMe SSD in a SATA M.2 slot. It won’t be detected.
- Choosing a heatsink version. It is often too thick for a mini-PC. The thermal pad that ships with the machine is usually enough.
- Assuming the SSD protects you from power cuts. Without advertised PLP, plan for a UPS and backups.
- Trusting retailer listings. DRAM and TBW figures there are often copied from another capacity. Only the manufacturer’s spec page counts.
- Disabling power management for no reason. On a 24/7 server, ASPM lowers idle power. Only turn it off if you actually see instability.
FAQ
Is a DRAM-less SSD enough for Proxmox?
For a few containers and light virtual machines, yes in most cases. For sustained writes (active databases, ZFS with many snapshots), a model with DRAM such as the 990 PRO handles the load more comfortably.
Does a PCIe 4.0 SSD work in a PCIe 3.0 mini-PC?
Yes. PCIe is backward compatible, but the slot will limit throughput. For homelab use you’ll barely notice.
What does “PCIe 5.0 x2” mean on the 990 EVO Plus?
Samsung states that the SSD can run as PCIe 4.0 over four lanes or PCIe 5.0 over two lanes. In a typical mini-PC it will usually run at PCIe 4.0 x4 or 3.0 x4.
Do I need an SSD with power-loss protection (PLP)?
It is rare on consumer M.2 2280 drives. In a mini-PC, a UPS, an automatic shutdown via NUT and regular backups are the more realistic combination.
How do I check my mini-PC’s form factor and interface?
Check the manual or the manufacturer’s spec page: number of M.2 slots, supported lengths, PCIe and/or SATA, PCIe generation. On Linux, lspci and nvme list identify the installed SSD.
To go further, see the Recommended hardware page and check compatibility with your mini-PC before buying.
Read also
Key facts
Our picks
Affiliate links · same price for youSamsung 990 EVO Plus 2 To
Amazon Black Friday Week runs through November 30
Amazon · price and availability on the listing
Samsung 990 PRO 4 To
Amazon Black Friday Week runs through November 30
Amazon · price and availability on the listing
Crucial T500 2 To
Amazon Black Friday Week runs through November 30
Amazon · price and availability on the listing
See all our recommended gear in the shop.